A gym at home is super convenient, but some of us don’t have room in the basement, garage, or first floor, or we’re stuck in an apartment building. It’s this situation where you have to consider whether your upstairs or second+ story floor can support your gym safely.
Table of Contents
In the US, residential building codes require that every bedroom support 30 pounds per square foot (psf), and other rooms support 40 psf.
However, it’s ok if you exceed that for a portion of the floor. Each square foot doesn’t have to individually be limited to 40 lbs.
Think of it this way. Would you be afraid to find two 300-lb people standing very close together in that room? It’s disturbing that they snuck into your home and you caught them, but your sense is that you wouldn’t have to worry about the structural integrity of the floor, right?
Modern construction standards require that you can fill a room by loading each square foot to 40 lbs. That also doesn’t mean each square foot can only take 40 lbs. If some portion of the floor is bare, you can still stack hundreds of pounds in one place, and the floor joists will distribute the load somewhat.
So back to gym equipment. For a gym involving weights I recommend putting down 3/4″ plywood, followed by 3/8″ to 3/4″ rubber mats (the thicker the better, but 3/8″ is fine if you aren’t dropping anything). The plywood spreads the load across multiple joists and serves as a good sturdy base layer over carpet if need be. The dense rubber spreads the load a little more, provides good traction, a slight amount of give, and it prevents a dropped weight from punching through the plywood.
Think of all the large bookcases and hot tubs on second floors. Bookcases are generally against a wall where there’s more floor support, and that helps a lot. But still, if some of the room isn’t holding much or any weight already, your joists can take more weight.
Often you can get away with up to 1500 lbs of gym equipment that does not involve any shock loads. There are probably some exceptions where you need to be more careful. I’m not a builder and don’t know much about it. But if we’re going to pick a number, that’s as good as any.
I recommend you get a professional (a structural engineer, ideally) to check things out and give you better advice than that arbitrary number. He can check out the spacing and size of the joists, and heck, maybe in an apartment building you’ll be lucky enough to be right over a steel I-beam. Or you’ll be unlucky enough to be in an old home that doesn’t meet current codes and barely can hold your weight, but at least fortunate enough to have learned that before you break through it.
If you’re dropping the barbell at all, the shock load goes way beyond its total weight, and you could run into trouble. We’ll get into that below.
Let’s look at a power rack / squat rack, olympic weights, and bench. I’ll give specific numbers here, and then you’ll see that the other types of equipment below will be even less of an issue.
An entry level power rack has about a 4’x4′ footprint.
Let’s say you’re a 200 lb guy and you bench press 200 lbs on a light duty rack.
A 130lb rack + 200lb person + 200lbs of weights + 100lb bench = 630 lbs.
Divide 635 lb / 16 sqft and you’re at 39 psf. Sounds dangerously close to the 40 psf max, right?
Well, as we discussed above, this is spread out by the floor joists, and hopefully by your rubber over plywood flooring. So even if you add a little “shock load” factor as you drop the weights on the rack, the rack base spreads that out, as does your rubber flooring. The weights hitting the floor directly is very different (see deadlifting below).
Another example: The popular Rogue RML-390F power rack weights about 300 lbs, you’re a bigger guy at 250 lbs, and you’re squatting 300 lbs. That totals . The footprint is 4’x4′. Do the math and you get 53 psf. Again, considering your flooring is spreading the load out, you’re effectively still within the 40 psf guideline. If you drop the weight on the rack pretty hard, that number goes up somewhat, but the numbers will be vastly different depending on how hard we’re talking about. At these levels, you’re probably okay but you’re getting into dangerous territory if you’re really rough with those heavy squats.
Short answer: You can do it if you take certain precautions, but you’re going to scare the hell out of your downstairs neighbor.
If you can always set it down gently you’ll be fine. But I’m not going to be the jerk that tells you to lift lighter weight for more reps so you can set the bar down gently. Deadlifts are your opportunity to do just a few reps with as much weight as humanly possible.
For setting a deadlift down hard, or even dropping it a couple feet, your best bet is sturdy crash pads. These are known to work effectively without sinking too much under the weight. Put down a stack of plywood and/or rubber tiles between them to get your feet level with them, basically making yourself a little lifting platform.
They absorb impact so well that you can probably even drop light cleans or snatches with them. You can experiment and get a feel for what a reasonable limit is.
An elliptical or any kind of indoor bike or rower is not going to cause damage. It’s not that heavy, not that noisy, and you aren’t creating any shock loads whatsoever, which is really where the danger lies in other equipment.
A treadmill will shake the floor and over time may cause some kind of damage or loosening of joints, assuming you’re running and not using it to walk while reading a book to clock in your fake workout time.
The modern curved-deck style of treadmill reduces foot pounding significantly. That isn’t really the point of the design, but it’s an effect of the the way you run on these and the way your feet don’t have as far to fall as you step forward.
Weight machines are not much of an issue, even if it’s the freeweight loaded type where you have a lot of weight plates sitting around. The machines don’t add much shock load even when you lower the weight arm or cable heavily. It’s not going to damage anything.
I have avoided talking much here about the noise factor of all these types of equipment. That’s a whole different post and has more to do with keeping your neighbors and housemates happy than worrying about damage to your floor.
See my separate post on the topic of how to work out in an apartment without making a racket.
View Comments
Hey my room is a 100 square feet room and I have a bed that weighs about 150 pounds in one corner of the room and some other furniter distrubuted in other places that prob combines to 140 so I was wondering if I can set up a power rack that will eventually be 700 pounds dead load weight in my room if I set it up and was wondering if I can set it up without it destroying my room floor which is a upstairs room and has carpet and is a house from 2006.
I'm looking at a functional trainer to put in my upstairs bonus room corner. It stands about 4.5ft x 4.5ft and 550 lbs. I know that's less than the 810psf but I'm more concerned about the static, concentrated weight of the weight stack. Are you saying I'll be fine even over time with the wood floor joists? I am wondering if that much concentrated weight will warp the floors? I'd love to add a functional weight machine to my home gym.
I don't think it would be a problem. In the corner of the room like that is the best spot to carry a load too. Bookcases loaded up can be very heavy and aren't a problem.
I would never put a heavy squat platform upstairs unless the floor was reinforced with concrete and steel. Way too risky. Better to keep in garage or downstairs in area reinforced.
Great article. We have a bonus room over our garage and have a treadmill, elliptical, spin bike, free weights, reformer, rower, and several smaller things. The room is FULL. But it's great. I've noticed that the walls are starting to show a few cracks. Our neighbor says that's just the drywall settling from probable the use of the treadmill, and that as long as we don't see a crack in the ceiling of our garage we are probably ok. What do you think? And who should I call to have it checked out?
It is great ! A spare bedroom is much smaller than my old house but I was able to fit my 220 pound weight stack cable system, elliptical, bike and free weights in the room and I shored the floors like you said to do . My daughter and future son in law were lucky to get all the other equipment that is commercial grade that I did not have room for . Thanks again !
Marlane, that's great you got everything in there! Most of that should be just fine. What kind of free weights do you have, how heavy?
Thanks for sharing this article. My sister and I are thinking on how we can achieve a gym inside our house. This article is very helpful. I like all the ides that you mentioned.
Great Article ! I am a Certified Personal Trainer with a commercial grade gym in my basement . I am downsizing to a condo without a basement so this info was very helpful ! My gym goes with me no matter what !
That's great, Marlane. Let me know how it works out!